Gate Alarm

A cheap and simple Gate Alarm, that is intended to run off a small universal AC-DC power supply.

IC1a is a fast oscillator, and IC1b a slow oscillator, which are combined through IC1c to emit a high pip-pip-pip warning sound when a gate (or window, etc.) is opened. The circuit is intended not so much to sound like a siren or warning device, but rather to give the impression: "You have been noticed." R1 and D1 may be omitted, and the value of R2 perhaps reduced, to make the Gate Alarm sound more like a warning device. VR1 adjusts the frequency of the sound emitted.

IC1d is a timer which causes the Gate Alarm to emit some 20 to 30 further pips after the gate has been closed again, before it falls silent, as if to say: "I’m more clever than a simple on-off device." Piezo disk S1 may be replaced with a LED if desired, the LED being wired in series with a 1K resistor.

Figure 2 shows how an ordinary reed switch may be converted to close (a "normally closed" switch) when the gate is opened. A continuity tester makes the work easy. Note that many reed switches are delicate, and therefore wires which are soldered to the reed switch should not be flexed at all near the switch. Other types of switches, such as microswitches, may also be used.

Copyright Rev. Thomas Scarborough
[Contact the author of this article at]Parts:IC1 = 4093B
R1 = 10K Ohm
R2 = 38K Ohm
R3 = 100K Ohm
VR = 25K Ohm potmeter
C1 = 10 uF
C2 = 10 nF
C3 = 10 uF
C4 = 100 uF
D1 = 1N4148
S1 = Piezo disk (or LED with 1K Ohm resistor ini series)

Leave a Reply

Your email address will not be published. Required fields are marked *